A full-body armor created by Future Rudeus with Zanoba, using hints from the document describing the Fighting God Armor worn by Figing God.
Constructed with technology researched in automata, making it completely different in abilities and performance from the Fighting God Armor.
Equipped with the operating mechanism based on Zalif’s prosthetic hand on the highest hardness outer plate that Future Rudeus can create, powered by the wearer’s magic.
Stands over 2 meters tall.
Has terrible fuel efficiency. Even Future Rudeus can only operate it at full power for half a day. However, at around 30% output, it can now hold its own against ordinary opponents.
Solves the issue of defense and reaction speed due to the inability to clad it in fighting spirit.
Eris was stronger than this Armored Future Rudeus.
Armor Made by Rudeus, Referencing Future Rudeus’ Armor
Additionally, it features a shield with Paulo’s sword at the tip for extra defense.
In emergencies, it can be activated with the command “Purge,” causing the back armor to burst open, allowing for a quick escape.
Constructed in just three months.
Designed for short-term battles, excelling in defense and firepower compared to Future Rudeus’ armor. However, it falls short in terms of maintenance, damage control, repairability, mobility, technicality, and endurance.
If operated at full capacity, it can only sustain combat for about an hour. Using the Gatling gun, which has the worst fuel efficiency, would shorten this time even further. In fact, Rudeus ran out of magic power during battle.
Rudeus, while wearing this armor, briefly achieved a lower-class ranking among the Great Powers.
Due to its large size, it needed to be disassembled if not worn. However, later on, it became summonable through the use of teleportation magic circles. During this process, the scroll bearing the magic circle is destroyed due to the weight of the magic armor.
Type 1 Modification, Type 2
Deemed necessary to improve after the battle against Orsted, the prototype of the magic armor was designated as ‘Type 1’.
While attempting to reduce its size while maintaining its capabilities, the attempt failed.
‘Type 1 Modification’ involved reducing its size by only a single size category, resulting in a failure where only the performance was compromised.
Retaining only the parts for arms and legs, ‘Type 2’ aimed to eliminate size and fuel efficiency issues by concentrating magic arrays on the limbs. It succeeded in a significant reduction in magic consumption (though it still consumes so much magic that only Rudeus can handle it), but due to the lack of magic flow through the torso, operating at full power could potentially tear the limbs from the body, requiring power to be saved for self-preservation.
Type 2 Modification
A new type of magic armored suit with supplementary magic arrays incorporated into the torso to address the flaws of Type 2.
It demonstrates strength on par with a Saintly class swordsman.
Becomes the main equipment after Chapter 19.
The armament in the arms has been changed from a Gatling gun to a shotgun.
Starting from Chapter 23, a Scroll Vernier has been installed on the back, eliminating the need to retrieve scrolls manually.
Type 3
A magic armored suit under development.
The concept of ‘Type 3’ is “small in size but high in performance.”
According to the Asura Kingdom’s biographical records, it is speculated that Lili Greyrat researched the magic armored suit ‘Type 3’ and developed a general-purpose magic armored suit based on it.
Type Zero
A magic armored suit developed for short-term decisive battles.
Stands at approximately 3 meters tall.
Equipped with a Gatling gun in the right hand, with Paulo’s sword at the tip of the fist. A shotgun is equipped in the left hand.
By increasing magic consumption several-fold, both mobility and armor are significantly enhanced. It was named ‘Prototype’ as its concept contradicted that of ‘Type 3’.
